- Super strong.
- Pre perforated with holes
- Thick and Shiny.
- Resistant to UV rays, they do not fade in the sun.
We recommend that the graphics motorcycle. stickers, be installed by a person specialized in doing this work, so that it is correctly installed and then it does not come off and there are no problems. What you need to know:
The plastic fuel tanks must be in good condition, if it is very worn, porous, the graphics will not last long, and it is not a problem with the graphics, but with the tank, you must restore or change it, and then install it of the graphics.
Our graphics are of excellent quality, have excellent adhesive and also have a thick, glossy laminate for protection.
“Applying decal graphics to motorcycles using the water method is an effective and simple technique that will allow you to achieve professional results. Before you begin, make sure you have everything you need: decal graphics, a spray bottle with water, and a plastic squeegee or credit card.
Step 1: Preparation
Make sure that the surface of the motorcycle is completely clean and free of dust and grease. Fill the sprayer with water and shake it to get a fine mist of water. You can also add a small amount of non-alcoholic liquid soap to the water to make it easier to adjust the chart.
Step 2: Remove the protective paper
Carefully peel the sticky graphic from its backing and spray the sticky part evenly with water. This will prevent the graphic from sticking immediately, giving you time to adjust its position.
Step 3: Positioning
Place the graphic in the desired position on the bike. Being moistened with water, you can easily slide the graph to find the perfect location. Make sure it is well aligned and centered.
Step 4: Smoothing and removing bubbles
With the graphic in place, use the plastic putty knife or credit card to gently smooth the graphic, removing any excess water and trapped air bubbles. Work from the center out to the edges for an even application and to avoid bubbles.
Step 5: Drying and finishing
Once the graphic is well positioned and free of bubbles, with a heat gun or hair dryer, dry from center to edges. BE CAREFUL NOT TO DAMAGE THE GRAPHICS! Then let it dry naturally for about 24 hours. This will allow the adhesion to be strengthened. Avoid washing the motorcycle or exposing it to rain during this time.
With the water application method, you will be able to achieve precise and trouble-free placement of the sticker graphics on your motocross bike. Enjoy a professional and custom look while protecting and enhancing the appearance of your bike.”